What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
08.06.2025 09:32

nine
so, what happens?
At one ohm, the resistor has a maximum of 1 watt power.
what exactly is a ‘surge’ protector?
Edit 2024–10.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
What are LGBT+ people tired of hearing?
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
the problem then depends on "how fast does the fuse operate?".
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
(Dc diagram shown, AC is similar).
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
What do you like the most about black people?
[image of Common-mode choke]
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
This is 'the assistant's answer'
What is the most peculiar thing about the human brain?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Now when you have a certain ac resistance, then a current flows in a loop.
One
How to Make AI Faster and Smarter—With a Little Help from Physics - WIRED
2024–10–10[John johnson John Johnson ]
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
eight
What do you think is the #1 cause of why relationships nowadays don't seem to last long?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Europe cuts interest rates as Trump's tariffs loom - BBC
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Here is a simplified AC power diagram.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
But… the neutral is now “floating” because of the 1 ohm resistance.
Treasuries Rally on Fed Cut Hopes, Stocks Hit Peak: Markets Wrap - Bloomberg
Upvotes:
Barnstars:
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
What kind of person makes you think "how come there are people like that"?
The other is “what does a “fuse” do?”
He then describes the function of a fuse.
An AC voltage/ current source, and an ac inductive load.
Europe stock markets fall after Trump doubles steel tariffs - CNBC
This is where the MOV conducts again, and dissipated the energy.
This is where this question deviates from being a 'generic' question, and becomes more specific.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Popular chicken chain shares, massive expansion plan - TheStreet
2024–10–14 [Omar Gharbi Omar Gharbi ]
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
[old diagram got deleted by accident]
but this device (an Inductor) … impedes the rapid changes in the current.
a photo is worth a thousand words.
The third is lightning and “how it gets conducted into a home.”
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
First Sentence:
It seems Mohan does not understand the difference between a comment and an Answer.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
The bolt then partially travels down the line to your home.
There are three different concepts here that are getting confused.
It also is a device that limits the change in current flow.
A fuse is a non-resetable over current circuit protector.
So, the voltage could go up to 500 volts, and the fuse will not open up.
The MOV will conduct when the voltage exceeds 50% of line voltage.
For this case there are devices called Metal oxide varistors (MOV).
These devices are installed between the “hot” and “neutral” and protective ground.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
One is “what exactly is in a ‘surge protector’ ? ”
He then asserts :
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
2024–10–16 [ OO OLAOYE OYEBODE ]
These are simplified answers to the original question, and does not change anything I wrote above.
This device then solves the entire problem.
But it can get overloaded, and no longer works.
I post the exact comment here.
There are two important concepts here.
but I think this circuit , shows a few more pieces.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
In schematic diagrams this is the symbol for a fuse:
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
He then describes Rainy Season and Lightning.
At least they know the answer if they wanted it.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
A circuit breaker is similar, but is resettable.
This one hit behind the barn.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Because the load is inductive, the current lags the voltage.(by a bit).
What does a fuse do?
What is lightning?